GE Indoor Furnishings R30 User Manual

R30 Recessed  
Light Extender  
User’s Manual  
 
Easy 1-2-3 installation  
4. Loosen the adjustment  
ring on the securing collar  
and slide the collar down the  
shaft towards the lamp hood  
until the collar is just above  
the ring line of the swivel joint.  
Your Recessed Light Extender  
is now ready to install.  
Installation  
1. Turn the power off to the  
fixture. Simply unscrew the  
light bulb from the existing  
recessed can light. Insert  
the light bulb into the  
Recessed Light Extender and  
screw securely into place.  
Note: For the R30 size Recessed Light  
Extender, use a R30 size light bulb.  
Use an incandescent, CFL or LED light  
bulb. Not for use with halogen light bulbs.  
2. Screw in the Recessed  
Light Extender into the  
recessed light socket  
until the screw base begins  
to click. The Recessed Light  
Extender has a safety ratchet  
mechanism to ensure the  
extender cannot be screwed  
in too far and damage  
the socket.  
3. Slide the cover ring up to  
the ceiling and tighten the  
adjustment ring for a snug  
fit. (The cover ring should  
cover most existing recessed  
light rings.)  
To direct light to a specific  
area, hold the extender shaft  
and position lamp hood to  
desired location using the  
rocker/swivel mechanism.  
Turn power back on...  
 
Troubleshooting  
- Ensure power to the Recessed Light Extender is  
turned “ON”.  
- Test your bulb in another fixture to ensure that  
the bulb is good.  
- Recessed Light Extender’s safety ratchet will begin to  
slip when the screw-in torque becomes too high. In this  
case the safety ratchet may begin to slip before the  
Recessed Light Extender is fully seated into the light  
socket, causing the Recessed Light Extender to not  
operate. These situations usually develop due to a  
corroded or misthreaded recessed light lamp socket.  
Please consult a qualified electrician if repair is required  
for a recessed light socket.  
!
WARNING  
RISK OF FIRE OR ELECTRIC SHOCK:  
• Turn OFF power before installation, removal  
or re-lamping  
• Do not exceed electrical ratings  
• For indoor use only  
• Install this kit only in the luminaires that has the  
construction features and dimensions shown in  
the photographs and/or drawings  
• Do not make or alter any open holes in an  
enclosure of wiring or electrical components  
during kit installation.  
• Do not alter, relocate, or remove wiring,  
lampholders, ballast, or any other  
electrical component  
Made in China / Hecho en China  
is a trademark of General Electric Company and is  
used under license to Jasco Products Company LLC, 10  
E. Memorial Road, Oklahoma City, OK 73114  
This Jasco product comes with a 1 year limited warranty.  
Este producto de Jasco Products tiene una garantía  
para detalles.  
45155-2  
120VAC 75W MAX  
3/26/10  
 

Eiki Projector LC 6000UL User Manual
Eizo Computer Monitor RX430 User Manual
Euro Pro Frozen Dessert Maker KP170E User Manual
Freecom Technologies Network Router FSG 3 User Manual
Fundex Games Board Games Cribbage User Manual
GE Mouse HO98535 User Manual
GE Washer WWA8810M User Manual
Gianni Industries Door LZ 300 User Manual
Gianni Industries Door LZ 400N User Manual
Giant Router LP122A 3100 User Manual